|
This translation is given as an information. Only the french version is legal. ( see the french version )
Important notice :
Install each element on a clean surface. Be sure to install all the rubber magnet elements correctly.
Make sure that the rubber magnet covers the car bodywork evenly.
When fitting the elements, make sure you leave a space of at least 5 mm from the edge.
Start with the doors, working from top to bottom.
Then continue with the other elements following the same process, starting with bigest elements as mud guard.
Lastly, install the small elements.
Don' t forget to clean both sides of the Protec Magnet before and after use.
The elements cannot be used when driving at high speeds.
When the temperature is very cold, it could be more difficult to install the elements for the front mud guards. Just press them on with your hands.
Should the Protec Magnet distort, place it in a warm place. After in few mintues it will warm up and then you can install it on the vehicle.
Do not place any electronic device ( telephone, GPS, computers, … ) on the magnet as this could interfare with functionment. ( this does not affect equipment inside the vehicle ).
When the outside temperature is high, do not use the Protec Magnet. Rubber tends to melt at 68°C and it could stick to the paintwork and in exceptional circumstances, result in damage the vehicule paintwork. Do not place your Protec Magnet kit on your car more than 4 days, and if the outside temperature is high, do not place it more than 12 hours.
Should the Protec Magnet distort, place it in a warm place. After in few mintues it will warm up and then you can install it on the vehicle. Do not place any electronic device ( telephone, GPS, computers, … ) on the magnet as this could interfare with functionment. ( this does not affect equipment inside the vehicle ).
With time, due to temperature changes, the elements could retract ( +/- 2% at least per metre )
Do ensure that the magnetic sign is removed regularly, cleaned with soapy water, not solvents, rinsed, dried and re-applied. Ideally this should be done every 5 days. In very hot weather, it MUST be done more often.
Do ensure that all of the magnetic sheet is in contact with the vehicle (avoid heavily contoured areas) to ensure maximum performance.
Do not use on body panels containing plastic filler since this will drastically reduce the magnetic performance
Storage :
If possible, store the elements flat, all elements facing the same way.
Keep in a dry place and do not forget to dry the elements properly before storage.
Spare parts :
It is possible to re-order any elements separatly.
Only the french version is legal. ( see the french version )
http://www.protec-magnet.com/conditions.html
|
|
